owners manual Seat Toledo

all ratings: 0 average rating: 5

Lights and visibility s cooled down, the window can be operated will remain on to light up the stationary vehi- Lights and visibility once again. cle in case this is necessary. ation ● Depending on weather conditions (cold orific Lights wet), the lights may mist up temporarily on pec s the inside. This is particularly the case in the Roll-back function on electric al Introduction event of a difference in temperature between windows hnic the inside and in front of the light. By switch- ec T The location of the controls of right-hand ing on the lights, the area through which the The electric windows are equipped with a drive cars differs slightly from the location beam of light is projected will quickly be roll-back system that reduces risk of injury shown here ››› Fig. 45 ››› page 61. However,demisted, although the edges may remain when closing windows. the symbols indicating the respective posi-misted. The real lights and turn signals can mist up. This has no influence on the usefule tions of the controls remain the same. If an obstacle is present, the closing mecha- ic life of the lighting system. nism will stop and the window will roll back a Adv WARNING few centimetres. Never drive with only the side lights on! The If an obstacle prevents closing for the next side lights are not bright enough to illumi-Sidelight and headlight 10 seconds, the closing mechanism will once nate the road ahead and to ensure that other again stop and the window will roll back an- road users are able to see you. Always use other few centimetres. your dipped beam headlights if it is dark or if visibility is poor. If in the next 10 seconds you attempt to close ation the window after it has rolled back the sec- ond time, only the closing mechanism will be CAUTION Oper stopped even if the obstacle is still present. ● Use the lights in line with local law. The roll-back function is still connected. ● However, drivers always remain responsi- The roll-back function will only be disconnec- ble for correctly adjusting and using the ted if you once again attempt to close the lights. window in the following 10 seconds. In this Fig. 45 Instrument panel: light control. case, the window will close at full force. ety Note Switching on side lights If you wait for a further 10 seconds, the roll- Saf ● An audible warning will be heard when the back function will be once again connected. – Turn the light switch ››› Fig. 45 to position light control is set to  and you remove the ignition key and open the door. Once the. » driver door is closed (ignition off), the audi- ble warning will stop, whereas the side lights 61

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders