owners manual Mercedes GL

all ratings: 0 average rating: 5

Technical data Fuels, coolants, lubricants Coolants If the antifreeze mixture is effective to To provide important corrosion protection, -35°F (-37°C), the boiling point of the cool-the solution must be at least 50% anticor- The engine coolant is a mixture of water ant in the pressurized cooling system is rosion/antifreeze (equivalent to freeze and anticorrosion/antifreeze, which reached at approximately 266°F (130°C).protection to approximately -35°F provides: The coolant solution must be used year [-37°C]). If you use a solution that is more
Corrosion protection round to provide the necessary corrosion than 55% anticorrosion/antifreeze (freeze protection and increase boil-over protec-protection to approximately -49°F
Freeze protection tion. Refer to Maintenance Booklet for [-45°C]), the engine temperature will
Boiling protection (by increasing the replacement interval.increase due to the lower heat transfer boiling point) capability of the solution. Therefore, do not Coolant system design and coolant used use more than this amount of anticorro- The cooling system was filled at the factory determine the replacement interval. The sion/antifreeze. with a coolant providing freeze protection replacement interval published in the to approximately -35°F (-37°C) and corro-Maintenance booklet is only applicable if If the coolant level is low, water and sion protection. MB325.0 Anticorrosion/Antifreeze solu-MB325.0 Anticorrosion/Antifreeze tion or other Mercedes-Benz approved should be used to bring it up to the proper !Add premixed coolant solution only. Adding level (have cooling system checked for water and MB 325.0 Anticorrosion/Antifreeze products of equal specification are used to signs of leakage). Please make sure the separately from each other, could cause engine renew the coolant concentration or bring it mixture is in accordance with label instruc- damage not covered by the back up to the proper level.tions. Mercedes-Benz Limited Warranty.For information on other Mercedes-Benz approved products of equal specification, The water in the cooling system must meet refer to the Factory Approved Service minimum requirements, which are usually Products pamphlet (USA only) or contact satisfied by normal drinking water. If you an authorized Mercedes-Benz Light Truck are not sure about the water quality, con- Center. sult an authorized Mercedes-Benz Light Truck Center. 565

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders