owners manual Hyundai i40

all ratings: 0 average rating: 5

Maintenance 5. Maximum permissible inflationTread wear WARNING - Tyre age pressure The tread wear grade is a compara- This number is the greatest amount Tyres degrade over time, even tive rating based on the wear rate of of air pressure that should be put in when they are not being used. the tyre when tested under controlled the tyre.Do not exceed the maximumconditions on a specified govern- Regardless of the remaining permissible inflation pressure. Refer ment test course.For example, a tyre tread, it is recommended that to the Tyre and Loading Information tyres generally be replaced graded 150 would wear one-and-a- label for recommended inflation after six (6) years of normal half times (1½) as well on the gov- service. Heat caused by hot cli-pressure. ernment course as a tyre graded mates or frequent high loading 100. 6. Maximum load rating conditions can accelerate the The relative performance of tyres aging process. Failure to followThis number indicates the maximum depends upon the actual conditions load in kilograms and pounds that this Warning can result in sud- of their use, however, and may can be carried by the tyre. When den tyre failure, which could depart significantly from the norm replacing the tyres on the vehicle, lead to a loss of control and an because of variations in driving always use a tyre that has the same accident involving serious habits, service practices and differ- injury or death. load rating as the factory installed tyre. ences in road characteristics and cli- mate. 4.Tyre ply composition and material7. Uniform tyre quality grading These grades are molded on the Quality grades can be found where The number of layers or plies of rub- side-walls of passenger vehicle applicable on the tyre sidewall ber-coated fabric are in the tyre.Tyre tyres.The tyres available as standard between tread shoulder and maxi- manufacturers also must indicate the or optional equipment on your vehi- mum section width. cles may vary with respect to grade. materials in the tyre, which include For example: steel, nylon, polyester, and others. The letter "R" means radial ply con- TREADWEAR 200 struction; the letter "D" means diago-TRACTION AA nal or bias ply construction; and the TEMPERATURE A letter "B" means belted-bias ply con- struction. 741

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders