owners manual Volvo 262

owners manual Volvo 262 - year of production: 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993 - Volvo 262 264 265 owners manual EN

Document: pdf (4.31 MB) 104 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Volvo 262, year of production 1974 - 1993:

1977 Volvo 262 264 265 I Engine Mechanical Components Torque manifold bolts The manifold bolts should be torqued at the 600 mile inspection. A loose manifold could alter air/fuel ratio and cause an increase in emission and/or poor driveability. Valves The valve clearance should be checked every 30,000 miles. Vacuum fittings, hoses and connections Unstable idle, misfiring or poor emission control is often caused by leaking vacuum hoses or connections. Check hoses and connections on distributor vacuum unit, EGR valve and connections heater control servo systems and hydraulic brake servo. pg. 51 Emission control systems II Engine Fuel System CI system The B27F engine is provided with a fuel injection system called the CI system (Continuous Injection), which means that the fuel injectors are open and inject fuel as long as the engine is operating. This system has few moving parts, is reliable and meets the exhaust emission standards at maximum efficiency. Air supplied to the engine is continuously measured and determines the amount of fuel injected. The air flow is regulated by two throttle valves. The air flow sensor and the fuel distributor are integrally built as a single unit. A lever is actuated by the air flow to produce continuous fuel distribution. Fuel 91 octane RON (Research Octane Number). Unleaded fuel permitted for all models and required for certain models (with catalytic converter). A label on the instrument panel and on the rear fender, near the filler inlet, will remind of this requirement. It is unlawful to dispense leaded fuel into a vehicle labeled "unleaded gasoline only". Special instructions for work on the fuel injection system Extreme cleanliness is essential when working on the injection system. Great care must be observed. Injection system service should be handled by qualified technicians, using equipment intended for this service. file:///K|/ownersdocs/1977/1977_262_264_265/77262264265_03a.htm (10 of 16)12/22/2006 10:08:30 PM

Download PDF

Click here to download a pdf file with an instruction manual for Volvo 262
year of production from: 1974

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.