owners manual Jeep Liberty

all ratings: 0 average rating: 5

INSTALLATION OF RADIO TRANSMITTING EQUIPMENT Special design considerations are incorporated into thisThe antenna cable should be as short as practical and vehicle’s electronic system to provide immunity to radiorouted away from the vehicle wiring when possible. Use frequency signals. Mobile two-way radios and telephoneonly fully shielded coaxial cable. equipment must be installed properly by trained person-Carefully match the antenna and cable to the radio to nel. The following must be observed during installation.ensure a low Standing Wave Ratio (SWR). The positive power connection should be made directlyMobile radio equipment with output power greater than to the battery and fused as close to the battery as possible.normal may require special precautions. The negative power connection should be made to body sheet metal adjacent to the negative battery connection.All installations should be checked for possible interfer- This connection should not be fused.ence between the communications equipment and the Antennas for two-way radios should be mounted on thevehicle’s electronic systems. roof or the rear area of the vehicle. Care should be used in mounting antennas with magnet bases. Magnets may affect the accuracy or operation of the compass on vehicles so equipped.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders