owners manual Ford Mustang

all ratings: 0 average rating: 5

Keys and Remote Controls E151796 E151957 1. Place the cap just forward of the key 1. Slide the release on the back of the cylinder. remote control and pivot the cover off. 2. While applying pressure to the cap, move it forward until it is in place. You may hear a snap as it engages. Make sure you have properly installed the cap by trying to move it rearward. Replacing the Battery Note:Refer to local regulations when disposing of transmitter batteries. Note:Do not wipe off any grease on the battery terminals or on the back surface of E153890 the circuit board. 2. Insert a coin into the slot and twist to Note:Replacing the battery will not delete separate the housing. the transmitter from the vehicle. The transmitter should operate normally. A message will appear in the information display when the remote control battery is low. See Information Messages (page 91). Intelligent Access Transmitter The remote control uses two coin-type three-volt lithium batteries CR2025 or equivalent. E153891 3. Remove the batteries. 4. Install new batteries with the + facing each other. Note:Make sure to replace the label between the two batteries. 47 Mustang (), enUSA, First Printing

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders