or
owners manual KIA Ceed
owners manual KIA Ceed - year of production: 2012 - KIA Ceed II 2 owners manual EN
Document:
pdf (40.04 MB) 643 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle KIA Ceed, year of production 2012:
JD PE eng 6.QXP 11/26/2015 5:03 PM Page 6
What to do in an emergency
Jump starting procedure ✽✽ NOTICE 4. Connect the jumper cables in the exact
If the battery is discharged, the enginesequence shown in the illustration.
CAUTION -AGM battery can be started using a battery of anoth-First connect one end of a jumper
(if equipped) er vehicle and two jumper cables. Onlycable to the positive terminal of the
Absorbent Glass Matt (AGM) bat-use jumper cables with fully insulateddischarged battery (1), then connect
teries are maintenance-free and the other end to the positive terminal
clamp handles.
we recommend that the AGM bat- To prevent personal injury ordamage toon the booster battery (2). Proceed to
teries be serviced by an author- connect one end of the other jumper
both vehicles, adhere strictly to the fol-
ized Kia dealer. For charging yourlowing procedure. cable to the negative terminal of the
AGM battery, use only fully auto- booster battery (3), then the other end
matic battery chargers that are to a solid, stationary, metallic point (for
1. Make sure the booster battery is 12-
specially developed for AGM bat- example, the engine lifting bracket)
volt and that its negative terminal is
teries. grounded. away from the battery (4). Do not con-
When replacing the AGM battery, nect it to or near any part that moves
2. If the booster battery is in another
we recommend that you use parts when the engine is cranked. Make
vehicle, do not allow the vehicles to
for replacement from an author- sure that there is no contact between
touch. the bodywork of the two vehicles; oth-
ized Kia dealer. 3.Turn off all unnecessary electrical
Do not open or remove the cap onloads. erwise, there is the danger of short cir-
top of the battery.This may cause cuits.
leaks of internal electrolyte that Do not allow the jumper cables to con-
could result in severe injury. tact anything except the correct battery
If the AGM battery is reconnected terminals or the correct ground. Do not
or replaced, ISG function will not lean over the battery when making
operate immediately. connections.
If you want to use the ISG func- CAUTION - Battery cables
tion, the battery sensor needs to
be calibrated for approximately 4 Do not connect the jumper cable from
hours with the ignition off. the negative terminal of the booster
battery to the negative terminal of the
discharged battery. This can cause
the discharged battery to overheat
and crack, releasing battery acid.
6 6
Download PDF
Click here to download a pdf file with an instruction manual for KIA Ceed
year of production from: 2012
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
KIA Ceed II 2 owners manual
pages 476 - 482
KIA Ceed II 2 owners manual
page 479 / 643
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF