owners manual Mazda 6

all ratings: 0 average rating: 5

Mazda6_8DQ8-EA-13L_Edition3 Page471 Friday, June 13 2014 6:23 PM Black plate (471,1) If Trouble Arises Flat Tire WARNING CAUTION Attach the speed restriction sticker in a ØDrivecarefully to an Authorized place where it can be viewed easily by MazdaDealerandkeepthe the driver: vehicle speed below 80 km/h (50 ØApplyingthespeedrestriction mph). sticker to the steering wheel is ØIfthevehicle is driven over 80 dangerous as it could interfere km/h(50mph),thevehicle might with the air bag deployment and begin to vibrate. result in serious injury. ØDonotapplythestickertoany NOTE position other than the position l If the tire is not properly inflated, the tire indicated in the illustration of the pressure monitoring system warning light speedometer. will illuminate (page 4-23). l Donotpressthe tire pressure monitoring 10. Switch the ignition ON (engine system set switch after installing the spare running). tire or after using the emergency flat tire 11. Turn the compressor on and wait until repair kit. The switch is only to be pressed the sealant is injected into the tire. after installing the repaired flat tire or After the sealant is injected into the installing a replacement tire (page 4-23). tire, continue waiting until the tire is 15. After driving the vehicle 5 km, set up inflated to the correct air pressure. the compressor again using Step 8 of NOTE the procedure. Turn the compressor l Check the tire inflation pressure label on and then off after a few seconds, (driver's door frame) for the correct tire and check the tire air pressure. If the inflation pressure. tire air pressure is low, turn the l If the tire air pressure is not correct after a compressor on again and wait until few seconds, the tire may be seriously the tire inflates to the correct air damaged. Consult an Authorized Mazda pressure. Dealer. CAUTION 12. Whenthe tire has been inflated to the ØIfthetire inflation pressure falls proper inflation pressure, turn the below 130 kPa (1.3 kgf/cm2 or bar, compressor switch off and remove the 18.9 psi), repair cannot be done hose from the tire valve. with the repair kit. Park the 13. Install the tire valve cap. vehicle on a level surface off the 14. Store the hose, removed from the right-of-way and contact an valve, in the trunk and resume driving Authorized Mazda Dealer. the vehicle. ØIfthetire inflation pressure continues to remain low, park the vehicle on a level surface off the right-of-way and contact an Authorized Mazda Dealer. 7-11 Form No.8DQ8-EA-13L

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders