Hummer H2 owners manual page 461

text version of content this owner's manual page from owners manual to the vehicle Hummer H2, year of production 2002 - 2010:

Maintenance Footnotes (e) Make sure the safety belt reminder light and all your # Lubricate the front suspension, ball joints, steeringbelts, buckles, latch plates, retractors, and anchorages linkage, transmission shift linkage, and parkingare working properly. Look for any other loose or brake cable guides. Ball joints should not be lubricateddamaged safety belt system parts. If you see anything unless their temperature is 10°F (-12°C) or higher,that might keep a safety belt system from doing its or they could be damaged. job, have it repaired. Have any torn or frayed safety belts replaced. Also look for any opened or broken airbag (a) Visually inspect brake lines and hoses for propercoverings, and have them repaired or replaced. hook-up, binding, leaks, cracks, chaﬁng, etc. InspectThe airbag system does not need regular maintenance. disc brake pads for wear and rotors for surface(f) Lubricate all key lock cylinders, hood latch condition. Inspect other brake parts, including calipers,assembly, secondary latch, pivots, spring anchor, parking brake, etc. release pawl, rear compartment hinges, outer liftgate (b) Visually inspect front and rear suspension andhandle pivot points, rear door detent link, roller steering system for damaged, loose, or missing parts,mechanism, liftgate handle pivot points, latch bolt, fuel signs of wear or lack of lubrication. Inspect powerdoor hinge, cargo door hinge, locks, and folding steering lines and hoses for proper hook-up, binding,seat hardware. More frequent lubrication may be leaks, cracks, chaﬁng, etc. Visually check constantrequired when exposed to a corrosive environment. velocity joints, rubber boots and axle seals for leaks.Applying silicone grease on weatherstrips with a clean (c) Visually inspect hoses and have them replacedcloth will make them last longer, seal better, and if they are cracked, swollen, or deteriorated. Inspectnot stick or squeak. all pipes, ﬁttings, and clamps; replace with genuineSpare tire carrier hinge and latch: Inspect for leaks and GMparts as needed. To help ensure proper operation,lubricate if required. Remove the setscrew at the a pressure test of the cooling system and pressurehinge casting and add lubricant, moving the hinge back cap and cleaning the outside of the radiator andand forth periodically, until lubricant can be seen air conditioning condenser is recommended at leastcoming from the setscrew opening. Install setscrew and once a year. tighten to 7 ft lb (9 Y). See Recommended Fluids (d) Visually inspect wiper blades for wear or cracking.and Lubricants on page 6-12 for what lubricant to use. Replace wiper blades that appear worn or damaged(g) Check vent hose at transfer case for kinks and or that streak or miss areas of the windshield.proper installation. 6-7

owners manual Hummer H2

owners manual Hummer H2 - year of production: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010 - Hummer H2 owners manual EN