owners manual Peugeot Partner

all ratings: 0 average rating: 5

Instruments and controls Zero re-set Oil level correct Dipstick Your PEUGEOT dealer or a qualiied A = maximum, never exceed 42workshop carries out this operation this level as a surplus of oil after each service. may damage the engine. However, if you carry out the service Contact a PEUGEOT dealer yourself, the re-set procedure is as or a qualiied workshop follows: Low oil level without delay. - switch off the ignition, Flashing of "OIL", B = minimum, top up the level - press and hold the trip recorder linked with the via the oil iller cap, using the reset button, service warning lamp, grade of oil suited to your accompanied by an engine. - switch on the ignition.audible signal and a message in the The display begins a countdown.screen, indicates a low oil level which When the display shows "=0", release could damage the engine. the button; the spanner disappears.If the low oil level is conirmed by a Trip recorder zero reset button check using the dipstick, it is essential that the level is topped up. With the ignition on, After this operation, if you wish to Oil level gauge faultpress the button until the disconnect the battery, lock the Flashing of "OIL--" zeros appear. vehicle and wait for at least ive indicates a malfunction minutes, otherwise the zero re-set will of the engine oil level not be registered. indicator. Contact a PEUGEOT dealer or a qualiied Lighting dimmer workshop. With the lighting on, press the button to vary Engine oil level indicatorThe level read will only be correct the brightness of the if the vehicle is on level ground instruments and controls. Depending on your vehicle's engine, and the engine has been off for When the lighting when the ignition is switched on, the more than 30 minutes.reaches the minimum engine oil level is indicated for a few (or maximum) setting, release the seconds, after the service information. button then press it again to increase (or reduce) the brightness. As soon as the lighting is of the required brightness, release the button. Partner-2-VU_en_Chap03_Pret-a-partir_ed02-2014Partner-2-VU_en_Chap03_Pret-a-partir_ed02-2014

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders