manual Audi R8 I 1 owners manual page 40

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 38 Mittwoch, 21. Februar 2007 1:32 13 38 Driver information system The message disappears after 5 seconds. Press the adjuster/test Applies to vehicles: with light sensor/ rain sensor 8 button ⇒page10, fig. 2 briefly if you wish to call up the message A Light sensor/rain sensor  again. This indicator lamp comes on if the automatic headlights/ If the display indicates that one of the lights is not working, this can automatic wipers are defective. have a number of causes: • Bulb failure ⇒ page 193. If the  symbol appears, this means that the light sensor/ rain • A “blown” fuse ⇒ page 190, “Changing fuses”. sensor is not functioning. For safety reasons, the dipped beam • Defective electrical wiring. headlights will then be switched on permanently when the light switch is set to the AUTO position. However, you can still switch the Have the components replaced or the wiring repaired as necessary lights on and off in the normal way with the light switch. If the rain by a qualified workshop. sensor is defective, the functions operated via the windscreen wiper lever will still be available. You should have the light sensor/ rain sensor checked by a qualified workshop as soon as possible. WARNING • Bulbs are sensitive to pressure. The glass can break when you Applies to vehicles: with R tronic touch the bulb, causing injury. Selector lever defective  and  • Incorrect handling of the high-voltage element of xenon gas- discharge bulbs can have potentially fatal consequences.   Selector lever defective! No R gear! If these symbols light up, there is a fault in the R tronic selector Brake light failure  lever. The indicators on the selector lever will go out or flash. It is no longer possible to engage reverse gear. If you were using the If the symbol  or the text BRAKE LIGHT lights up, check the gearbox in manual mode, it will switch back to automatic mode. following components: You can continue to change gear manually. Starting in neutral (N), pull the + paddle lever on the steering wheel to engage first gear. • Brake light bulbs A • Wiring connections The gearbox will now remain in manual mode and you can select the • Brake light switch gears using the paddle levers. You should have the selector lever checked by a qualified workshop Have the components repaired or replaced by a qualified workshop.as soon as possible. Note Applies to vehicles: with R tronic The brake light switch is only tested during the initial systems check Clutch overheating  and  after starting the engine.   Clutch is overheating ! If possible please stop vehicle.

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN