owners manual Hummer H3

owners manual Hummer H3 - year of production: 2005, 2006, 2007, 2008, 2009, 2010 - Hummer H3 owners manual EN

Document: pdf (5.94 MB) 416 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Hummer H3, year of production 2005 - 2010:

(d) Inspect wiper blades for wear, cracking, or(g) Check vent hose at transfer case for kinks and contamination. Clean the windshield and wiper blades, ifproper installation. contaminated. Replace wiper blades that are worn or(h) Change automatic transmission ﬂuid and ﬁlter if the damaged. See Windshield Wiper Blade Replacement onvehicle is mainly driven under one or more of these page5-52 and Windshield, Backglass, and Wiperconditions: Blades on page 5-97 for more information.− In heavy city traffic where the outside temperature (e) Make sure the safety belt reminder light and safetyregularly reaches 90°F (32°C) or higher. belt assemblies are working properly. Look for any− In hilly or mountainous terrain. other loose or damaged safety belt system parts. If you− When doing frequent trailer towing. see anything that might keep a safety belt system from doing its job, have it repaired. Have any torn or− Uses such as found in taxi, police, or delivery frayed safety belts replaced. Also see Checkingservice. the Restraint Systems on page 1-69.(i) Drain, ﬂush, and reﬁll cooling system. This service (f) Lubricate all key lock cylinders, hood latch assembly,can be complex; you should have your dealer/retailer secondary latch, pivots, spring anchor, release pawl,perform this service. See Engine Coolant on page 5-27 rear compartment hinges, outer swing-gate handle pivotfor what to use. Inspect hoses. Clean radiator, points, rear door detent link, roller mechanism,condenser, pressure cap, and ﬁller neck. Pressure test swing-gate handle pivot points, latch bolt, fuel doorthe cooling system and pressure cap. hinge, locks, and folding seat hardware. More frequent(j) A ﬂuid loss in any vehicle system could indicate a lubrication may be required when exposed to aproblem. Have the system inspected and repaired and corrosive environment. Applying silicone grease onthe ﬂuid level checked. Add ﬂuid if needed. weatherstrips with a clean cloth will make them last longer, seal better, and not stick or squeak.(k) Visually inspect belt for fraying, excessive cracks, or obvious damage. Replace belt if necessary. 6-8

Download PDF

Click here to download a pdf file with an instruction manual for Hummer H3
year of production from: 2005

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.