owners manual Mercedes E

all ratings: 0 average rating: 5

Changing aw heel 371 X Mounting an ew wheel Clean the wheel and wheel hub contact surfaces. G WARNING X Slide the wheel to be mounted onto the Oiled or greased wheel bolts or damaged alignment bolt and push it on. wheel bolts/hub threads can cause the wheel X Tighten the wheel bolts until they are bolts to come loose .A s a result, you could finger-tight. lose a wheel while driving. There is a risk of X Unscrew the alignment bolt. accident. X Tighten the last wheel bolt until it is finger- Never oil or grease wheel bolts. In the event tight. of damage to the threads, contact a qualified specialist workshop immediately.H ave the Lowering the vehicle damaged wheel bolts or hub threads replaced/renewed. Do notc ontinue driving. G WARNING The wheels could work loose if the wheel nuts G WARNING and bolts are not tightened to the specified If you tighten the wheel bolts or wheel nuts tightening torque. There is a risk of accident. when the vehicle is raised, the jack could tip Have the tightening torque immediately over. There is a risk of injury. checked at a qualified specialist workshop Only tighten the wheel bolts or wheel nuts after a wheel is changed. when the vehicle is on the ground. Always pay attention to the instructions and safety notes in the "Changing a wheel" section (Y page 367). Only use wheel bolts that have been designed for the wheel and the vehicle. For safety reasons, Mercedes-Benz recommends that tires and ls Whee you only use wheel bolts which have been approved for Mercedes-Benz vehicles and the respective wheel. ! To prevent damage to the paintwork, hold Tightening the wheel nuts (example: vehicle with the wheel securely against the wheel hub an emergency spare wheel) while screwing in the first wheel bolt. X Turn the crank of the jack counter- clockwise until the vehicle is once again standing firmly on the ground. X Place the jack to one side. X Tighten the wheel bolts evenly in a crosswise pattern in the sequence indicated (: to A). The specified tightening torque is 96 lb-ft(130 Nm). X Turn the jack back to its initial position. X Stow the jack and the rest of the vehicle tools in the trunk again. Positioning a wheel (example: vehicle with an emergency spare wheel) Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders