owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 365 d2ureepe, Version: 2.11.8.1 Fuels, coolants, lubricants, etc.365 water. Otherwise, the BlueTEC exhaust gasand increase boil-over protection. Refer to aftertreatment system could be damaged.the Maintenance Booklet for replacement interval. Damage caused by using additives or diluting with water are not covered by theCoolant system design and coolant used Mercedes-Benz Limited Warranty. determine the replacement interval. The replacement interval published in the Purity Maintenance Booklet is only applicable if MB 325.0 Anticorrosion/Antifreeze solution ® The purity of AdBlue is of particular or other Mercedes-Benz approved products importance for avoiding malfunctions in the of equal specification are used to renew the exhaust gas aftertreatment. coolant concentration or bring it back up to ® If AdBlue is pumped out of the tank, e.g.the proper level. during repair work, the same liquid must not For information on other Mercedes-Benz be used to refill the tank as its purity is no approved products of equal specification, longer guaranteed. contact an authorized Mercedes-Benz Center or visit www.mbusa.com (USA only). ! Impurities caused for example by other service products, cleaning agents, and dustTo provide important corrosion protection, result in increased emissions, the solution must be at least 50% malfunctions, catalyst damage, or engineanticorrosion/antifreeze (equivalent to damage. freeze protection to approximately -35‡ [-37†]). If you use a solution that is more than 55% Technical data Coolants anticorrosion/antifreeze (freeze protection to approximately -49‡ [-45†]), the engine The engine coolant is a mixture of water and temperature will increase due to the lower anticorrosion/antifreeze, which provides: heat transfer capability of the solution. R Corrosion protection Therefore, do not use more than this amount R of anticorrosion/antifreeze. Freeze protection If the coolant level is low, water and MB 325.0 R Boiling protection (by increasing the boiling Anticorrosion/Antifreeze should be used to point) bring it up to the proper level (have cooling The cooling system was filled at the factory system checked for signs of leakage). Please with a coolant providing freeze protection to make sure the mixture is in accordance with approximately -35‡ (-37†) and corrosion label instructions. protection. The water in the cooling system must meet ! Add premixed coolant solution only. minimum requirements, which are usually Adding water and MB 325.0 Anticorrosion/satisfied by normal drinking water. Antifreeze separately from each other, If you are not sure about the water quality, could cause engine damage not covered by contact an authorized Mercedes-Benz the Mercedes-Benz Limited Warranty. Center. If the antifreeze mixture is effective to -35‡ (-37†), the boiling point of the coolant in theAnticorrosion/antifreeze pressurized cooling system is reached at Your vehicle contains a number of aluminum approximately 266‡ (130†). parts. The use of aluminum components in The coolant solution must be used year round motor vehicle engines necessitates that to provide the necessary corrosion protection anticorrosion/antifreeze coolant used in Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders