owners manual Volvo V70

all ratings: 0 average rating: 5

2004 VOLVO V70 The stability systems consist of a number of functions: The following two functions are common to both STC/DSTC 1. Traction control (TC) This function is designed to help reduce wheel spin by transferring power from a drive wheel that begins to lose traction to the wheel on the opposite side of the car (on the same axle). TC monitors and compares the rotational speed of the drive wheels. If one of the drive wheels shows a tendency to spin, the difference in speed is immediately detected. This triggers the Anti-lock Brake System, which brakes the spinning wheel until the difference in rotational speed is corrected. TC is most active at low speeds, and a pulsating sound will be audible when the system is regulating wheel spin. This is quite normal. This is one of the STC/DSTC's permanent functions and is not affected when the button on the center control panel is pressed. 2. Spin control (SC) The spin control function is designed to help prevent the drive wheels from spinning while the car is accelerating. This is done by temporarily reducing engine torque to the drive wheels, which helps improve stability and tractive force. Under certain circumstances, such as when driving with snow chains, or driving in deep snow or loose sand, it may be advisable to temporarily switch off this function for maximum tractive force. This is done by pressing the STC/DSTC button on the center control panel for at least a half a second. When the SC function has been switched off: ● The text window (see page 27) will briefly display "SPIN CONTROL OFF" ● The LED in the STC/DSTC button will be off. The following two functions are only available with DSTC: 3. Active Yaw Control (AYC) This function helps maintain directional stability, for example when cornering, by braking one or more of the wheels if the car shows a tendency to skid or slide laterally. This is done by activating the Anti- lock Braking System. A pulsating sound will be audible when the function is active, which is quite normal. If you apply the brakes while this function is active, the brake pedal will feel stiffer than usual. This is also one of the DSTC system's permanent functions and is not affected when the DSTC button on the center control panel is pressed. R-models only: The AYC function can be deactivated. This is done by pressing the DSTC button on the center control panel (see the illustration on page 31) for approximately one second. This procedure must be repeated 5 times, after which "DSTC REDUCED FUNCTION" will be displayed in the text window. AYC will be file:///K|/ownersdocs/2004/2004_V70/04v70_01b.htm (13 of 15)12/30/2006 4:31:53 PM

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders