owners manual Fiat Freemont

all ratings: 0 average rating: 5

4. Place the shift lever momentarily into each gear• If the fluid level is low, add fluid through the dipstickKNOWING position (allowing time for the transmission to fullytube to bring it to the proper level. Do not overfill.YOUR engage in each position), ending with the transmis-After adding any quantity of oil through the dipstickVEHICLE sion in PARK. tube, wait at least two minutes for the oil to fully 5. Wipe the area around the dipstick clean to preventdrain into the transmission before rechecking the dirt from entering the transmission.fluid level. SAFETY 6.Remove the dipstick and determine if the fluid is8. Check for leaks. Release the parking brake. hotorcold.Hotfluidisapproximately82°C,whichTo prevent dirt and water from entering the transmis-STARTING is the normal operating temperature after the ve-sionaftercheckingorreplenishingfluid,makesurethatAND hicle is driven at least 24 km. Hot fluid cannot bethe dipstick cap is properly re-seated.DRIVING held comfortably between the fingertips. Cold fluid WARNING is at a temperature of approximately 27° C.• Using a transmission fluid other thanLIGHTS the manufacturer’s recommended fluidAND 7. Wipe the dipstick clean and reinsert it until seated.may cause deterioration in transmissionMESSAGES Then, remove the dipstick and note the fluid levelshift quality and/or torque converter shudder,andIN AN on both sides. The fluid level reading is only valid ifwillrequire more frequent fluid and filterEMERGENCY there is a solid coating of oil on both sides of thechanges.Referto“Fluids,Lubricants,andGenuine dipstick. Note that the holes in the dipstick will beParts” in "Technical Specifications" for fluid full of fluid if the actual level is at or above the hole.specifications.SERVICING • If the fluid is hot, the fluid level should be in the• Dirt and water in the transmission can causeANDCARE crosshatched area marked “HOT” (between the up-serious damage.To prevent dirt and water from per two holes in the dipstick).entering the transmission after checking or re-TECHNICAL •If the fluid is cold, the fluid level should be betweenplenishingfluid,makesurethatthedipstickcapisSPECIFICATIONS the lower two holes in the area marked “COLD.”re-seated properly. CONTENTS 353

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders