or
owners manual KIA Picanto
owners manual KIA Picanto - year of production: 2011 - KIA Picanto II 2 owners manual EN
Document:
pdf (32.74 MB) 488 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle KIA Picanto, year of production 2011:
What to do in an emergency
Jump starting procedure 1. Make sure the booster battery is 12-
CAUTION - Battery cables
volt and that its negative terminal is
CAUTION -AGM battery grounded. Do not connect the jumper cable
(if equipped) 2. If the booster battery is in another vehi-from the negative terminal of the
Absorbent Glass Matt (AGM) bat-cle, do not allow the vehicles to touch.booster battery to the negative ter-
3. Turn off all unnecessary electrical loads.minal of the discharged battery.
teries are maintenance-free and This can cause the discharged bat-
4. Connect the jumper cables in the
we recommend that the system tery to overheat and crack, releas-
be serviced by an authorized Kiaexact sequence shown in the illustra-
dealer. For charging your AGMtion. First connect one end of a jumpering battery acid.
cable to the positive terminal of the
battery, use only fully automatic
battery chargers that are special- jump start connector (1), then connect5. Start the engine of the vehicle with the
ly developed for AGM batteries.the other end to the positive terminal
on the booster battery (2).booster battery and let it run at 2,000
When replacing the AGM battery, rpm, then start the engine of the vehi-
use only the Kia genuine battery Proceed to connect one end of the
cle with the discharged battery.
for the ISG system. other jumper cable to the negative ter-If the cause of your battery discharging is
Do not open or remove the cap onminal of the booster battery (3), then
not apparent, we recommend that the
top of the battery.This may causethe other end to the negative terminal
of the jump start connector (4). Do notsystem be checked by an authorized Kia
leaks of internal electrolyte that dealer.
could result in severe injury.connect it to or near any part that
If the AGM battery is reconnectedmoves when the engine is cranked.
or replaced, ISG function will not Do not allow the jumper cables to con-
operate immediately. tact anything except the correct bat-
tery terminals or the correct ground.
If you want to use the ISG func-
Do not lean over the battery when
tion, the battery sensor needs to
be calibrated for approximately 4making connections.
hours with the ignition off.
6 6
Download PDF
Click here to download a pdf file with an instruction manual for KIA Picanto
year of production from: 2011
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
KIA Picanto II 2 owners manual
pages 347 - 353
KIA Picanto II 2 owners manual
page 350 / 488
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF