Audi R8 I 1 owners manual page 33

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 31 Mittwoch, 21. Februar 2007 1:32 13 Driver information system 31 Resuming the lap time session later The speed warning function will warn you if the vehicle exceeds the pre-set maximum speed. The system gives an audible warning When you have evaluated the lap times, you can resume the signal if the set speed is exceeded by about 10 km/h. A warning session and continue recording lap times later. symbol will also appear in the display ⇒ fig. 28. – Keep pressing the Reset button until the lap timer The speed warning function has two different warning levels*, appears ⇒page30, fig. 27. which operate independently and serve slightly different purposes: – Press the top part of the rocker switch to start recording Speed limit warning 1  a new lap time. With speed limit warning 1, the maximum speed can be changed while driving. The speed limit that has been set remains stored until – To record further lap times, repeat the procedure the ignition is switched off. described earlier ⇒ page 29, “Recording further lap The speed limit warning symbol  for speed warning 1 ⇒ fig. 28 times”. To evaluate the ov erall results, refer to ⇒ page 30, will appear in the display if you exceed the pre-set speed. It goes out “Finishing the session and evaluating or resetting lap again if the speed is reduced below the set speed limit. times”. The symbol also goes out if the speed is increased to more than about 40 km/h above the set speed for at least 10 seconds. However, Speed warning function this does not cancel the speed limit that was originally set. Setting speed limit warning 1 ⇒ page 32. Applies to vehicles: with speed warning function Speed limit warning 2  Introduction With speed limit warning 2, the speed limit can only be changed or The speed warning function can help you keep below a cleared when the ignition is switched off. You are recommended to pre-set maximum speed. store this speed limit warning if you always wish to be reminded of a particular speed limit. This could be when driving in countries with general speed limits, or if you need to keep below a particular speed when winter tyres are fitted, etc. The speed limit warning symbol  for speed warning 2 will appear in the display if you exceed the pre-set speed. Unlike speed limit warning 1, the warning symbol only goes out once the road speed has dropped below the stored value again. Setting speed limit warning 2 ⇒ page 32. Fig. 28 Display: Speed warning Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN