owners manual Volvo XC70

all ratings: 0 average rating: 5

10 Maintenance and servicing Onboard Diagnostic System • If you had recent service that required Booking service and repairs disconnecting the battery, OBD II diag- OBD II is part of your vehicle's computerized Connected Service Booking (CSB) makes set- nostic information may be incomplete engine management system. It stores diag- ting up a time for service, maintenance and/or and "not ready" for inspection. A vehicle nostic information about your vehicle's emis- repairs directly from the vehicle quick and that is not ready may fail inspection. 10 sion controls. It can light the Check Engine convenient. How can I prepare for my next OBD II light (MIL) if it detects an emission control Prerequisites "fault." A "fault" is a component or systememission inspection? • The owner (primary driver) must have a that is not performing within an expected • If your Check Engine (MIL) light is lit – or valid Volvo ID. See Volvo ID (p. 21) for range. A fault may be permanent or tempo- was lit but went out without service, have additional information. rary. OBD II will store a message about any your vehicle diagnosed and, if necessary, serviced by a qualified Volvo technician. The vehicle must be connected to the fault. • ® Internet using a paired Bluetooth cell • If you recently had service for a lit Check Emission inspection readiness phone. See your Sensus Infotainment Engine light, or if you had service that supplement for information on pairing a How do states use OBD II for emission required disconnecting the battery, a cell phone. On models equipped with period of driving is necessary to bring the inspections? Volvo On Call (VOC)*, you can connect to OBD II system to "ready" for inspection. Many states connect a computer directly to a the Internet using your separate VOC Two half-hour trips of mixed stop-and- vehicle's OBD II system. The inspector can data plan. Refer to your separate Volvo go/highway driving are typically needed then read "faults." In some states, this type of On Call manual. to allow OBD II to reach readiness. Your inspection has replaced the tailpipe emission Volvo retailer can provide you with more • By default, the retailer where you pur- test. information on planning a trip. chased your vehicle will be your preferred How can my vehicle fail OBD II emission (primary) retailer/Volvo authorized work- • Maintain your vehicle in accordance with inspection? shop who will perform service and repairs your vehicle's maintenance schedule. Your vehicle can fail OBD II emission inspec- on your vehicle. To change the preferred tion for any of the following reasons. retailer, go to Dealer Locator at volvocars.com and select a retailer, click • If your Check Engine (MIL) light is lit, your on Service Scheduler and book an vehicle may fail inspection. appointment at the new preferred retailer. • If your vehicle's Check Engine light was • In order to be guided through the on- lit, but went out without any action on screen steps, the menu alternative your part, OBD II will still have a recorded Display notifications must be activated. fault. Your vehicle may pass or fail, depending on the inspection practices in CSB menu access your area. Once the prerequisites have been estab- lished, all CSB-related menus can be }} * Option/accessory, for more information, see Introduction.325

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders