owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 324 d2ureepe, Version: 2.11.8.1 324 Flat tire iVehicles without spare wheel are not surfaces, such as tiled floors, you should use factory-equipped with the tools required for a non-slip underlay, for example a rubber mat. a wheel change such as a jack or a wheel Do not use wooden blocks or similar objects wrench. Some tools required for a wheel to support the jack. Otherwise the jack may change are specific to your vehicle. not be able to achieve its load-bearing Contact an authorized Mercedes-Benz capacity if it is not at its full height. Center to obtain the tools approved for Never start the engine when the vehicle is your vehicle. This section describes the raised. wheel change using the tools approved and Also observe the notes on the jack. recommended for your vehicle. XPrevent the vehicle from rolling away by Lifting the vehicle blocking wheels with wheel chocks or other sizeable objects. GWarning! When your vehicle is equipped with a wheel When jacking up the vehicle, only use the jack chock, it is included with the vehicle tool kit which has been specifically approved by (Y page 268). For information on setting up Mercedes-Benz for your vehicle. the collapsible wheel chock, see The jack is designed exclusively for jacking up (Y page 270). the vehicle at the jack take-up brackets built into both sides of the vehicle. Make sure theWhen changing a wheel on a level surface: Practical hints jack arm is fully seated in the jack take-up XPlace a wheel chock or other sizeable bracket. The jack must always be vertical object in front of and another wheel chock when in use, especially on inclines or or other sizeable object behind the wheel declines. that is diagonally opposite to the wheel The jack is intended only for lifting the vehicle being changed. briefly for wheel changes. It is not suited for Always try lifting the vehicle using the jack on performing maintenance work under the a level surface. However, should vehicle. To help avoid personal injury, use the circumstances require you to do so on a hill: jack only to lift the vehicle during a wheel change. XPlace wheel chocks or other sizeable objects on the downhill side in front of both Never get beneath the vehicle while it is wheels on the side opposite to the side on supported by the jack. Keep hands and feet which the wheel is to be changed. away from the area under the lifted vehicle. Always lower the vehicle onto sufficient GWarning! capacity jackstands before working under the Only jack up the vehicle on level ground or on vehicle. slight inclines/declines. Otherwise, the Always engage the parking brake firmly and vehicle could fall off the jack and injure you or block the wheels with wheel chocks or other others. sizeable objects before raising the vehicle with the jack. Do not disengage the parking brake while the vehicle is raised. Make sure that the ground on which the vehicle is standing and where you place the jack is solid, level and not slippery. If necessary, use a large underlay. On slippery

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders