owners manual Hummer H3

owners manual Hummer H3 - year of production: 2005, 2006, 2007, 2008, 2009, 2010 - Hummer H3 owners manual EN

Document: pdf (5.94 MB) 416 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Hummer H3, year of production 2005 - 2010:

TPMSSensor Matching Process The TPMS sensor matching procedure is outlined Each TPMS sensor has a unique identiﬁcation code.below: Any time you replace one or more of the TPMS sensors1. Set the parking brake. or rotate your vehicle’s tires, the identiﬁcation codes2. Turn the ignition switch to ON/RUN with the need to be matched to the new tire/wheel position.engine off. The sensors are matched to the tire/wheel positions in3. Turn the exterior lamp switch from AUTO to OFF the following order: driver side front tire, passengerfour times within three seconds. A double horn side front tire, passenger side rear tire, and driver sidechirp will sound and the TPMS low tire warning light rear tire using a TPMS diagnostic tool. See yourstarts ﬂashing. The double horn chirp and ﬂashing dealer/retailer for service. TPMSwarning light indicates the TPMS matching The TPMS sensors can also be matched to eachprocess has started. The TPMS warning light tire/wheel position by increasing or decreasing the tire’sshould continue ﬂashing throughout the matching air pressure. If increasing the tire’s air pressure, doprocedure. The LOW TIRE message displays on the not exceed the maximum inﬂation pressure indicated onDriver Information Center (DIC). the tire’s sidewall. To let air-pressure out of a tire you4. Start with the driver side front tire. can use the pointed end of the valve cap, a pencil-style5. Remove the valve cap from the valve cap stem. air pressure gage, or a key. Activate the TPMS sensor by increasing or You have one minute to match the ﬁrst tire/wheeldecreasing the tire’s air pressure for 10 seconds, position, and ﬁve minutes overall, to match all fourthen stop and listen for a single horn chirp. tire/wheel positions. If it takes longer than one minute,The single horn chirp should sound within to match the ﬁrst tire and wheel, or more than15seconds, conﬁrming that the sensor identiﬁcation ﬁve minutes to match all four tire and wheel positions,code has been matched to this tire and wheel the matching process stops and you need to start over.position. If you do not hear the conﬁrming single horn chirp, turn the ignition switch to LOCK and start over beginning with Step 2. 5-67

Download PDF

Click here to download a pdf file with an instruction manual for Hummer H3
year of production from: 2005

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.