Mitsubishi Outlander PHEV III 3 owners manual page 323

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Outlander PHEV, year of production 2012:

B０0203201E３.book 12 ページ㸰㸮㸯㸱年㸯㸯月㸯９日　火曜日　午前㸯㸯時５㸮分 Tyre repair kit CAUTION CAUTION 17.Affix the speed restriction sticker (R) to zAny sand or dust sucked into the compressorzIf the compressor becomes sluggish or hotthe three-diamond mark on the steering could make the compressor break down. Dowhile operating, it is overheating. Immedi-wheel. not place the compressor directly on anyately place the switch in the OFF position sandy or dusty surface when using it.and let the compressor cool down for at least zDo not disassemble or modify the compres-30 minutes. sor. Also, do not subject the air pressure gauge to shock. It could malfunction.NOTE 15.Check and adjust the tyre pressure withzIf the tyre pressure does not rise to the speci- reference to the air pressure gauge on thefied level within 10 minutes, the tyre may be compressor. If you overinflate the tyre,so severely damaged that the tyre sealant release air by loosening the hose’s end fit-cannot be used to effect an emergency repair. ting. Please contact a MITSUBISHI MOTORS 9 If there is a gap between the tyre andAuthorised Service Point or another special- wheel because the tyre has moved inwardist in this event. CAUTION from the wheel rim, press the periphery of zDo not affix the sticker anywhere except the the tyre towards the wheel to close the gap16.Turn OFF the compressor switch, thenspecified position on the pad of the steering before running the compressor. (With nopull the power cord plug out of the socket.wheel. Affixing the sticker in an incorrect gaps, the tyre pressure will rise.) position could prevent the SRS airbag from CAUTION NOTE working normally. zBe careful not to get your fingers trappedzSimply putting sealant and air into the tyre between the tyre and wheel as the tyreusing the tyre repair kit does not seal the inflates. puncture hole. Air will leak through the zThe surface of the compressor will get hotpuncture hole until the emergency repair pro- while the compressor is running. Do notcedure is completed (through step 19 or step keep the compressor running continuously20 of these instructions). for more than 10 minutes. After using the compressor, wait for the compressor to cool before using it again. 9-12 For emergencies

owners manual Mitsubishi Outlander PHEV

owners manual Mitsubishi Outlander PHEV - year of production: 2012 - Mitsubishi Outlander PHEV III 3 owners manual EN