or
owners manual KIA Ceed
owners manual KIA Ceed - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012 - KIA Ceed I 1 owners manual EN
Document:
pdf (29.62 MB) 442 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle KIA Ceed, year of production 2006 - 2012:
What to do in an emergency
Jump starting procedure 5.Proceed to connect one end of the
Push-starting
other jumper cable to the negative ter-
Your manual transaxle-equipped vehicle
minal of the booster battery (3), then
CAUTION - ISG battery should not be push-started because it
the other end to a solid, stationary,
Absorbent Glass Matt (AGM) bat- might damage the emission control sys-
metallic point (for example, the enginetem.
teries are maintenance-free and
lifting bracket) away from the battery
should only be serviced by an Vehicles equipped with automatic
(4). Do not connect it to or near any
authorized KIA dealer. For charg- transaxle cannot be push-started.
part that moves when the engine is
ing your AGM battery, use only Follow the directions in this section for
cranked.
fully automatic battery chargers jump-starting.
Do not allow the jumper cables to con-
that are specially developed for
AGM batteries. tact anything except the correct battery
When replacing the AGM battery, terminals or the correct ground.Do notWARNING
lean over the battery when making
use only the KIA genuine battery Never tow a vehicle to start it
for the ISG system. connections. because the sudden surge forward
when the engine starts could cause
CAUTION - Battery cablesa collision with the tow vehicle.
1. Make sure the booster battery is 12-
Do not connect the jumper cable
volt and that its negative terminal is
from the negative terminal of the
grounded. booster battery to the negative ter-
2. If the booster battery is in another
minal of the discharged battery.
vehicle, do not allow the vehicles comeThis can cause the discharged bat-
in contact. tery to overheat and crack, releas-
ing battery acid.
3.Turn off all unnecessary electrical
loads.
4. Connect the jumper cables in the exact6. Start the engine of the vehicle with the
sequence shown in the illustration.
booster battery and let it run at 2,000
First connect one end of a jumper
rpm, then start the engine of the vehi-
cable to the positive terminal of the
cle with the discharged battery.
discharged battery (1), then connect
If the cause of your battery discharging is
the other end to the positive terminal
not apparent, you should have your vehi-
on the booster battery (2).cle checked by an authorized KIA dealer.
65
Download PDF
Click here to download a pdf file with an instruction manual for KIA Ceed
year of production from: 2006
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
KIA Ceed I 1 owners manual
pages 313 - 319
KIA Ceed I 1 owners manual
page 316 / 442
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF