Infiniti Q45 III 3 owners manual page 313

text version of content this owner's manual page from owners manual to the vehicle Infiniti Q45, year of production 2001 - 2006:

O Trailer tire condition, size, load rating O The hitch should not be attached to orand proper inflation pressure should circuits. Using a module/converter that ex- affect the operation of the impact-be in accordance with the trailer andceeds these power requirements may dam- absorbing bumper. tire manufacturers’ specifications.age the vehicle’s electrical system. See a O Donot modify the vehicle exhaust sys-Safety chains reputable trailer dealer to obtain the proper tem, brake system, etc. to install a equipment and to have it installed. trailer hitch. Always use a suitable chain between your vehicle and the trailer. The safety chainsTrailer lights should comply with federal O To reduce the possibility of additionalshould be crossed and should be at- and/or local regulations. For assistance in damage if your vehicle is struck fromtached to the hitch, not to the vehicle hooking up trailer lights, contact an the rear, where practical, remove thebumper or axle. Be sure to leave enoughINFINITI dealer or reputable trailer hitch and/or receiver when not in use.slack in the chains to permit turning cor-dealer. After the hitch is removed, seal the boltners. Trailer brakes holes to prevent exhaust fumes, waterTrailer lights or dust from entering the passenger If your trailer is equipped with a braking compartment. CAUTION system, make sure it conforms to federal O Regularly check that all trailer hitch and/or local regulations and that it is mounting bolts are securely mounted. properly installed. When splicing into the vehicle electrical system, a commercially available power-WARNING Tire pressures type module/converter must be used to provide power for all trailer lighting. ThisNever connect a trailer brake system di- O When towing a trailer, inflate the ve-unit uses the vehicle battery as a directrectly to the vehicle brake system. hicle tires to the recommended cold power source for all trailer lights while us- tire pressure indicated on the tire anding the vehicle tail light, stoplight and turn loading information label.signal circuits as a signal source. ThePre-towing tips Refer to the “Tire and loading informa-module/converter must draw no more thanO Be certain your vehicle maintains a tion label” earlier in this section for15 milliamps from the stop and tail lamplevel position when a loaded or un- label location. loaded trailer is hitched. Do not drive Technical and consumer information 9-19 Z04.4.16/F50-D X

owners manual Infiniti Q45

owners manual Infiniti Q45 - year of production: 2001, 2002, 2003, 2004, 2005, 2006 - Infiniti Q45 III 3 owners manual EN