owners manual Jeep Liberty

all ratings: 0 average rating: 5

312 MAINTAINING YOUR VEHICLE To check the automatic transmission fluid level properly,(cross-hatched area) on the oil level indicator. The fluid the following procedure must be used:level indicator should be in the COLD region at 70° F (21° 1. The vehicle must be on level ground.C) fluid temperature. 2. The engine should be running at curb idle speed for aIf the fluid level is low, add sufficient fluid to bring to the minimum of 60 seconds. proper level. Refer to Recommended Fluids, Lubricants and Genuine Parts for correct fluid type. 3. Fully apply parking brake. Fluid is added through the dipstick tube. 4. Apply the brakes and shift the transmission into PNOTE: To prevent dirt and water from entering the (Park). transmission after checking or replenishing fluid, make 5. The fluid MUST be checked with the transmission incertain that the dipstick cap is properly reseated. P (Park) to be sure that the fluid level is accurate.Special Additives 6. Wipe the dipstick clean and reinsert until seated.The manufacturer recommends against the addition of Remove dipstick and note reading.any additives to the transmission. Exception to this At normal operating temperature (approximately 180° Fpolicy is the use of special dyes to aid in detecting fluid (82° C), the fluid level is correct if it is in the HOT regionleaks.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders