owners manual Skoda Kodiaq

all ratings: 0 average rating: 5

In the case of failure of an LED lamp or an LED, visit a specialist garage.Read and observe and on page ĘĕĞ first. 3ARNING 0he vehicle is equipped with headlights with halogen bulbs or LED light sour- ces. ■ Always read and observe the warnings before completing any work in the engine compartment » page ėĜĝ. Bulb arrangement » Fig. ĘĜĘ ■ Accidents can be caused if the road in front of the vehicle is not suffi- A Low beams with halogen bulb / LED light sources ciently illuminated and the vehicle cannot or can only be seen with difficul- B Flashing ty by other road users. C Main beam and side lights ■ HĜ and Hĝ bulbs are pressurised and may burst when changing the bulb - risk of injury! 3e therefore recommended wearing gloves and safetyD Fog lights glasses when changing a bulb. Change bulb for low beam (halogen headlight) CA10ION ■ Do not take hold of the glass bulb with naked fingers (even the smallest amount of dirt reduces the working life of the light bulb). 1se a clean cloth, napkin, or similar. ■ 0he cap of the filament bulb must always be seated correctly in the head- light, otherwise this may allow water and debris to enter the headlight - risk of damage to the headlights. Note ■ 0his Owner's Manual only describes the replacement of bulbs where it is pos- sible to replace the bulbs on your own without any complications arising. Other Fig. ĘĜę Changing the bulb for the low beam bulbs must be replaced by a specialist garage. ■ 3e recommend that a box of replacement bulbs always be carried in the ve- Read and observe and on page ĘĕĞ first. hicle. ›Remove the protective cap A » Fig. ĘĜĘ on page ĘĕĞ. Bulb arrangement in the headlights 0urn the holder with the bulb in the direction of arrow Ė » Fig. ĘĜę. › ›Remove the holder with the bulb in the direction of arrow ė . ›Remove the bulb from the holder in the direction of the arrow Ę . Fig. ĘĜĘ ›Insert a new bulb into the connector so that the lug A on the connector Left headlight snaps into the groove on the bulb. ›Insert the connector with the new bulb into the headlight in the opposite di- rection to the arrow ė . ›0urn the connector with the new bulb in the opposite direction to the arrow Ė until it stops. ›Fit the protective cap A » Fig. ĘĜĘ on page ĘĕĞ. Fuses and light bulbs ĘĕĞ

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders