owners manual Nissan Altima

all ratings: 0 average rating: 5

ThebrightnessoftheBlindspotindicatorlightsis3. To set the BSW system to on or off, use adjusted automatically depending on the bright-thebuttons to navigate in the menu ness of the ambient light. and use the ENTER button to select or A chime sounds if the camera unit has alreadychange an item: detected vehicles when the driver activates the● Select“BlindSpot”andpresstheENTER turn signal. If a vehicle comes into the detectionbutton. zoneafterthedriveractivatestheturnsignal,then● To turn on the warning, use the ENTER only the Blind spot indicator light flashes and nobuttontocheckboxfor“Warning(BSW)” chime sounds. (See “BSW driving situations” later in this section.) Thewarningsystemsswitchisusedtotemporar- Turning on or off the BSW system ily turn off the warning systems (Lane Departure Warning(LDW)andBlindSpotWarning(BSW) The BSW system is turned on or off using thesystems) that are activated using the settings SSD1026 settings menu in the vehicle information display.menu in the vehicle information display. See Detection zone SYSTEMON: “Warning systems switch” in “Instruments and The camera unit can detect vehicles on eitherThe BSWlight on the instrument panel will lightcontrols.” side of your vehicle when part of another vehicleup. WARNING is within the detection zone shown as illustrated.SYSTEMOFF: This detection zone typically starts from the out-The BSW light on the instrument panel will go● The camera unit may not be able to side mirror of your vehicle and extends approxi-out. detect whencertainobjectsarepresent mately 10 ft (3.0 m) behind the rear bumper, and such as: approximately 10 ft (3.0 m) sideways.1. Press thebutton until “Settings” dis-– Pedestrians, bicycles, animals plays in the vehicle information display. Use– Sometypesofsmallvehiclessuchas NOTE: the to select “Driver Assistance”.motorcycles, and very short length TheBlindspotindicatorlightwillilluminateThen press the ENTER button. vehicles for a few seconds when the ignition switch2. Select “Driving Aids”, and press the ENTER– Oncomingvehicles is placed in the ON position. button. Starting and driving 5-21

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders