owners manual Mercedes E

all ratings: 0 average rating: 5

Features 307 X Press and hold button B on remot ec ontrol Notes on programming the remote control A until indicator lamp : lights up green. If indicator lamp : lights up green or Canadia nr adio frequency laws require a "break" (or interruption) of the transmission flashes, then programming has been signals after broadcasting for a few seconds. successful. Therefore, these signals may no tl ast long X Release button B on remote control A for enough for the integrated garage door the garage door drive system. opener. The signal is notr ecognized during X If indicator lamp : lights up red: repeat programming. Comparable with Canadian the programming procedure for the law, some U.S.g arage door openers also corresponding button on the rear-view feature a "break". mirror. When doing so, vary the distance Proceed as follows: between remote control A and the rear- R if you live in Canada view mirror. R if you have difficulties programming the i If the indicator lamp flashes green after garage door opener (regardless of where successful programming, the garage door you live) when using the programming system is using a rolling code. After steps programming, you must synchronize the X Press and hold one of buttons ; to ? on garage door opener integrated in the rear- features and the integrated garage door opener. Stowage view mirror with the receiver of the garage Afte rashort time, indicator lamp : lights door system. up yellow. Synchronizing the rolling code X Release the button. Observe the "Important safety notes" Indicator lamp : flashes yellow. (Y page 305). X Press button B of garage door remote Your vehicle must be within reach of the control A for two seconds, then release it garage door or exterior gate drive. Make sure for two seconds. that neither your vehicle nor any persons/ X Press button B againf or two seconds. objects are present within the sweep of the X Repeat this sequence on button B of door or gate. remote control A until indicator lamp : X Turn the SmartKey to position 2 in the lights up green. ignition lock. If indicator lamp : turns red, repeat the X Press the program button of the door or process. gate drive (see the door or gate drive X Continue with the other programming operating instructions, e.g. under steps (see above). "programming of additional remote controls"). Problems when programming i Usually, you now have 30seconds to If you are experiencing problems initiate the next step. programming the integrated garage door X Press previously programmed button ;, opener on the rear-view mirror, take note of = or ? of the integrated garage door the following instructions: opener until the door closes. R Check the transmitter frequency of garage The rolling code synchronization is then door drive remote control A.T his can complete. usually be found on the back of the remote control. Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders