owners manual KIA Rio

all ratings: 0 average rating: 5

What to do in an emergency Do not allow the jumper cables to Jump starting procedure 1.Make sure the booster battery is contact anything except the correct Absorbent Glass Matt (AGM) batter-12-volt and that its negative termi- ies are maintenance-free and shouldnal is grounded.battery terminals or the correct ground. Do not lean over the bat- 2.If the booster battery is in another only be serviced by an authorized tery when making connections. vehicle, do not allow the vehicles to Kia dealer. For charging your AGM touch. battery, use only fully automatic bat- tery chargers that are specially 3.Turn off all unnecessary electrical developed for AGM batteries.loads. WARNING - Battery When replacing the AGM battery, cables 4.Connect the jumper cables in the use only the Kia genuine battery for Do not connect the jumper cable the ISG system. exact sequence shown in the illus-from the negative terminal of the tration. First connect one end of a booster battery to the negative jumper cable to the positive termi- terminal of the discharged bat- nal of the discharged battery (1), ✽✽ NOTICE tery. This can cause the dis- then connect the other end to the If the AGM battery is reconnected charged battery to overheat and positive terminal on the booster or replaced, ISG function will not crack, releasing battery acid. operate immediately. battery (2). Proceed to connect one end of the If you want to use the ISGfunction, 5.Start the engine of the vehicle with other jumper cable to the negative the battery sensor needs to be cali- the booster battery and let it run at terminal of the booster battery (3), brated for approximately 4 hours 2,000 rpm, then start the engine of then the other end to a solid, sta- with the ignition off and then, turn the vehicle with the discharged the engine on and off 2 or 3 times.tionary, metallic point (for example,battery. the engine lifting bracket) away If the cause of your battery discharg- from the battery (4). Do not con- Do not open or remove the cap on ing is not apparent, you should have nect it to or near any part that top of the battery.This may cause themoves when the engine is cranked.your vehicle checked by an author- ized Kia dealer. leak of dangerous internal elec- trolytes. 6 6

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders