owners manual Nissan Altima

all ratings: 0 average rating: 5

STARTINGTHEENGINE 1. Apply the parking brake.accelerator pedal by depressing theNOTE: 2. Move the shift lever to P (Park) or N (Neu-brakepedalandpushingthepush-buttonCare should be taken to avoid situations tral). P (Park) is recommended.ignition switch to start the engine. If thethat can lead to potential battery discharge engine starts, but fails to run, repeat theandpotential no-start conditions such as: Thestarterisdesignednottooperateifabove procedure. the shift lever is in any of the driving 1. Installation or extended use of electronic positions. CAUTION accessories that consume battery power 3. Push the ignition switch to the ON position.Do not operate the starter for more thanwhentheengineisnotrunning(Phonechar- Depress the brake pedal and push the igni-15 seconds at a time. If the engine doesgers, GPS, DVD players, etc.) tion switch to start the engine.not start, push the ignition switch to the2. Vehicle is not driven regularly and/or only To start the engine immediately, push andOFFposition and wait 10 seconds beforedriven short distances. In these cases, the release the ignition switch while depressingcranking again, otherwise the starterbattery may need to be charged to maintain the brake pedal with the ignition switch incould be damaged.battery health. any position. 4. Warm-up REMOTESTART(ifsoequipped) ● If the engine is very hard to start in ex-Allow the engine to idle for at least 30 sec-Vehicles started with the remote start require the tremely cold weather or when restarting,onds after starting. Do not race the engineignition switch to be placed in the ON position depresstheacceleratorpedalalittle (ap-while warming it up. Drive at moderatebefore the shift lever can be moved from the P proximately 1/3 to the floor) and whilespeedforashortdistancefirst, especially in(Park)position.Toplacetheignitionswitchtothe holding, crank the engine. Release thecold weather. In cold weather, keep the en-ONposition, follow these steps: accelerator pedal whentheenginestarts.gine running for a minimum of2-3minutes 1. Make sure that the Intelligent Key is on you. ● If the engine is very hard to start becausebefore shutting it off. Starting and stopping2. Apply the brake. itis flooded, depress the acceleratorthe engine over a short period of time may pedal all the way to the floor and hold it.makethevehicle more difficult to start.3. Press the ignition switch once to the ON Push the ignition switch to the ON posi-5. Tostoptheengine,shifttheshiftlevertotheposition. tiontostartcrankingtheengine.After5orP (Park) position and push the ignitionFor additional information, see “NISSAN Intelli- 6seconds, stop cranking by pushing theswitch to the OFF position.gent Key®” in the “Pre-driving checks and ad- ignition switch to LOCK. After cranking justments”section of this manual. theengine,releasetheacceleratorpedal. Crank the engine with your foot off the 5-12 Starting and driving

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders