owners manual Jeep Grand Cherokee

all ratings: 0 average rating: 5

298 STARTINGANDOPERATING Shift Positions Shifting Procedures Foradditionalinformationontheappropriateuseofeach4WDHIto4WDLOW transfer case mode position, see the information below:With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), 4WDHI key ON or engine running, shift the transmission into Allroadssurfacessuchasice,snow,gravel,sand,anddryNEUTRAL, and raise the transfer case T-handle. The hard pavement. “4WD LOW” indicator light in the instrument cluster, will begin to flash and remain on solid when the shift is NEUTRAL complete. Release the T-handle. Disengages both the front and rear driveshafts from theNOTE: If shift conditions/interlocks are not met, or a powertrain. To be used for flat towing behind anothertransfer case motor temperature protection condition vehicle. Refer to “Recreational Towing” in Section 5 ofexists, a “CHECK SHIFT PROCEDURES” message will this manual. flash from the EVIC (Electronic Vehicle Information Cen- 4WDLOW ter). Refer to “Electronic Vehicle Information Center Low speed four-wheel drive. Locks the front and rear(EVIC)” in Section 4 of this manual. driveshafts together. Forces the front and rear wheels to rotate at the same speed. Additional traction and maxi- mum pulling power for loose, slippery road surfaces only. Do not exceed 25 mph (40 km/h).

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders