owners manual Seat Ateca

all ratings: 0 average rating: 5

Wheels Wheel tread change cator must be recalibrated. Do the same, for Tyre monitoring indicator a example, when the front and rear wheels are at The wheel tread changes when: d swapped. al ●Tyre pressure is manually changed ●Switch the ignition on. hnic ●Tyre pressure is insufficient ec ● T Save the new tyre pressure in the Easy Con- ●Tyre structure is damaged 1) nect system by using the  button and the ●The vehicle is unbalanced because of a Setup ›› page 26. function button ›  load e When driving, the system self-calibrates the ic ●The wheels on an axle are subject to a tyre pressure provided by the driver and the Adv heavier load (e.g. with a heavy load). wheels fitted. After a long journey with varied ●The vehicle is fitted with snow chains speeds the programmed values are collected Fig. 227 Instrument panel: warning of loss of and monitored. ●The temporary spare wheel is fitted tyre pressure. With the wheels under very heavy loads, the ●The wheel on one axle is changed tyre pressure must be increased to the total The tyre monitor indicator compares wheel ation There may be a delay in the reaction of the recommended tyre pressure before the cali- revolutions and, with this information, the tyre  monitoring indicator or it may not in- bration ››› page 303. Oper tread of each wheel using the ABS sensors. If dicate anything under certain circumstances the rolling circumference of one or more (e.g. sporty driving, snow-covered or un- Note wheels has changed, the tyre monitoring in- paved roads, or when driving with snow s dicator will indicate this on the instrument ● The tyr e monitoring indicator does not ie chains). panel through a warning lamp and a warning function when there is a fault in the ESC or enc to the driver ››› Fig. 227. When only one spe- ABS ››› page 173. g cific tyre is affected, its position within the ● An erroneous indication may be given when Calibrating the tyre monitoring indica- Emer vehicle will be indicated. snow chains are in use because they increase tor the tread of the wheel.  Loss of pressure: Check left tyre pressure! After changing the tyre pressure or replacing one or more wheels, the tyre monitoring indi- ety Saf 1) In vehicles that are not equipped with the Easy Connect system, the switch for adjusting tyre pres- sure is located in the centre console next to the haz- ard warning lights. 297

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders