Mitsubishi Lancer VIII 8 owners manual page 296

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Lancer, year of production 2007 - 2016:

Automatic air conditioning with Fahrenheit scale (if so equipped) Enable automatic air conditioning control: NOTE 2.Select the temperature control dial to the When the mode selection dial or blower desired temperature. The temperature can While the mode selection dial is set between speed selection dial has been set to thebe set within a range of around 61 to 89. “ ” and “ ” position, the air condition- “AUTO” position or when the tempera- The temperature will increase as the dial ing will run automatically, even if the system ture control dial has been set to the mini- is turned to the right. is set to “Disable automatic air conditioning mum temperature, the air conditioning3.Set the mode selection dial to the control”, in order to prevent windows from switch is automatically controlled. fogging up. “AUTO” position. Disable automatic air conditioning con- The vents (except between “ ” and “ ”), trol: Operating the air conditioning recirculation/outside air, blower speed, and The air conditioning switch is not auto- ON/OFF of air conditioning will be con- system (automatic mode) matically controlled, unless the air condi- N00731700345trolled automatically. 7 tioning switch is used. Changing the settings: NOTE Press the air conditioning switch for about Set the temperature at about 75 under normal 10 seconds or longer. conditions. When the setting has changed, the system While the engine coolant temperature is low, will beep and the indicator light will flash. the temperature of the air from the heater will be cool/cold until the engine warms up, When the setting has changed from enabled to disabled, even if you have selected warm air with the the system will beep three times and the dial. To prevent the windshield and windows indicator will flash three times. from fogging up, the vent mode will be When the setting has changed from dis- changed to “ ” or “ ” and the blower speed will be reduced. abled to enabled, In normal conditions, use the system in the AUTO mode and follow these procedures: the system will beep two times and the indicator light will flash three times. 1.Set the blower speed selection dial to the Operating the air conditioning NOTE “AUTO” position. system (manual mode) The factory setting is “Enable automatic air N00731800072 conditioning control”. Blower speed and vent mode may be con- trolled manually by setting the blower speed selection dial and the mode selection dial to Comfort controls 7-21

owners manual Mitsubishi Lancer

owners manual Mitsubishi Lancer - year of production: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 - Mitsubishi Lancer VIII 8 owners manual EN