owners manual Seat Ateca

all ratings: 0 average rating: 5

Advice – Note the warnings ››› in Important safety WARNING WARNING arnings for handling a vehicle battery on w ● When repairing or working on the electrical Never charge a battery that has frozen: re- page 290 and ››› . system, proceed as follows: place battery! Failure to do so may lead to an – Switch off all electrical devices. Remove theexplosion. – 1. Remove the key from the ignition. The ey ignition k. negative cable on the battery must be disconnected. – Raise the bonnet ››› page 283. Note – 2. When the repair is finished, reconnect Use only the terminals in the engine compart- – Open the battery cover. the negative pole of the battery. ment to charge the battery. ● – Connect the charger clamps as described Switch off all electrical devices before re- connectin to the positive pole of the battery (+) and g the battery. Reconnect first the positive cable and then the negative cable.exclusively to an earth on the bodywork Replacing the battery Never reverse the polarity of the connections. (–). This could cause an electrical fire. – Only use a charger which is compatible forThe new battery should have the same speci- ● Ensure that the vent hose is always connec- use with 12 V nominal voltage batteries.fications (amperage, load and voltage) as the ted to the battery. The charge must not exceed a voltage of 15used battery. ● Never use damaged batteries. This could V. Your vehicle is equipped with an intelligent cause an explosion! Replace a damaged bat- – Now connect the battery charger to thepower management system to control the tery immediately. power socket and switch on. ››› distribution of electrical energy page 274. The power management function ensures CAUTION – After charging the battery: switch off the that the battery is charged much more effi- battery charger and disconnect the power ● Never disconnect the battery if the ignition ciently than on vehicles without a power socket cable. is switched on or if the engine is running. management system. To maintain this func- This could damage the electrical system or – Finally disconnect the charger cables from tion after replacing the battery, we recom- electronic components. the battery. mend that the replacement battery used is of the same make and type as the original fitted – Replace the battery cover correctly. battery. To make proper use of the power Charging the battery – Close the bonnet ››› page 283. management function after the battery has been changed, have the battery coded to the Important: Before you charge the battery Terminals for charging the battery are fitted power management mode at a specialised make sure you read the manufacturer's in- in the engine compartment. workshop. structions for using the battery charger. 290

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders