owners manual Mercedes GLA

all ratings: 0 average rating: 5

288 Features XPressandholdoneofbuttons;to?on operate in the frequency range of 280 to the integrated garage door opener. 433MHz. After a short time, indicator lamp : lights RReplacethebatteries in garage door upyellow. remote control A. This increases the like- XReleasethebutton. lihood that garage door remote control A Indicator lamp : flashes yellow. will transmit a strong and precise signal to the integrated garage door opener. XPressbutton Bofgaragedoorremote control A for two seconds, then release itRWhenprograming,holdremotecontrolA for two seconds. at varying distances and angles from the button which you are programing. Try vari- XPressbutton Bagainfortwoseconds. ous angles at a distance between 2and XRepeatthis sequence on button B of 12inches(5to30cm)oratthesameangle remote control A until indicator lamp : features but at varying distances. lights up green. RIfanotherremotecontrolisavailableforthe Whenindicator lamp : lights up green: and samegaragedoordrive, repeat the same programing is finished. programingstepswiththisremotecontrol. Whenindicatorlamp:flashesgreen:pro- Before performing these steps, make sure gramingwassuccessful.Thenextstepisto that new batteries have been installed in synchronize the rolling code. garage door drive remote control A. XReleasebuttonBofremotecontrolAof Stowage RNotethatsomeremotecontrolsonlytrans- the garage door drive. mit for a limited amount of time (the indi- If indicatorlamp:lightsupred:repeatthe catorlampontheremotecontrolgoesout). programing process for the corresponding PressbuttonBonremotecontrolAagain buttonontherear-viewmirror.Whendoing before transmission ends. so, vary the distance between remote con- RAligntheantennacableofthegaragedoor trol A and the rear-view mirror. openerunit.Thiscanimprovesignalrecep- The required distance between remote tion/transmission. control A and the integrated garage door opener depends on the garage door drive Opening/closing the garage door system. Several attempts might be neces- sary. You should test every position for at After it has been programed, the integrated least 25 seconds before trying another garage door opener performs the function of position. the garage door system remote control. Please also read the operating instructions Problemswhenprograming for the garage door system. If you are experiencing problems programing XTurntheSmartKeytoposition2intheigni- the integrated garage door opener on the tion lock (Y page 143). rear-view mirror, take note of the following XPressbutton;,=or?whichyouhave instructions: programed to operate the garage door. RCheckthetransmitter frequency used by Garagedoorsystemwithafixedcode:indi- garage door drive remote control A and cator lamp : lights up green. whether it is supported. The transmitter Garage door system with a rolling code: frequencycanusuallybefoundontheback indicator lamp : flashes green. of the garage door drive remote control. The transmitter will transmit a signal as long Theintegrated garage door opener is com- as the button is pressed. The transmission is patible with devices that have units which halted after a maximum of ten seconds and

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders