Subaru Impreza IV 4 owners manual page 289

text version of content this owner's manual page from owners manual to the vehicle Subaru Impreza, year of production 2011 - 2016:

Black plate (316,1) 7-14 Starting and operating &Service mode &Remotetransmitter program one time. In service mode, the remote engine startNew transmitters can be programmed to7. Repeat step 5 for any additional function is temporarily disabled to preventthe remote engine start system in thetransmitters (the system will accept up to the system from unexpectedly starting theevent that a transmitter is lost, stolen,eight transmitters). engine while being serviced. damaged or additional transmitters are8. The system will exit the transmitter To engage or disengage service mode:desired (the system will accept up to eightlearn mode if the key is turned to the 1. Enter the vehicle and close all vehicletransmitters). New remote engine start“LOCK” position, the door is closed or doors and the trunk/rear gate.transmitters can be programmed accord-after 2 minutes. 2. Verify that the select lever is in the “P”ing to the following procedure. position (CVT models) 1. Open the driver’s door (the driver’s&Systemmaintenance 3. Depress and hold the brake pedaldoor must remain opened throughout theNOTE 4. Turn the ignition switch to the “ON”entire process). In the event that the vehicle’s battery is position 2. Depress and hold the brake pedal.replaced, discharged or disconnected, 5. Press and release the remote engine3. Turn the ignition switch to “ON” thenit will be necessary to start the vehicle start transmitter “” button three times.“LOCK”, back to “ON” then “LOCK”, backa minimum of one time using the key The system will honk the vehicle’s hornto “ON” then “LOCK”, then back to “ON”prior to activating the remote engine each time the button is pressed.again and leave the ignition “ON” through-start system. This is required to allow 6. The system will pause for 1 secondout the programming process.the vehicle electronic systems to re- then honk the vehicle’s horn three times to4. The system will flash the side markersynchronize. indicate that the service mode has beenlights, tail lights and parking lights and engaged or honk one time to indicate thathonk the horn three times, indicating that! Changing the batteries the service mode has been disengaged.the system has entered the transmitter learn mode. CAUTION NOTE 5. Press and release the “ ” button on. Donotletdust,oilorwatergeton the transmitter that you want to program.or in the remote engine start Whentakingyourvehicleinforservice,6. The system will flash the side markertransmitter when replacing the it is recommended that you inform thelights, tail lights and parking lights andbattery. service personnel that your vehicle ishonk the horn one time, indicating that the equipped with a remote engine startsystem has learned the transmitter. Upon. Be careful not to damage the system. successful programming, the remote startprinted circuit board in the re- confirmation transmitter button will flashmote engine start transmitter when replacing the battery. 北米Model "A1120BE-B" EDITED: 2011/ 10/ 28

owners manual Subaru Impreza

owners manual Subaru Impreza - year of production: 2011, 2012, 2013, 2014, 2015, 2016 - Subaru Impreza IV 4 owners manual EN