owners manual Jeep Cherokee

all ratings: 0 average rating: 5

286 UNDERSTANDINGTHEFEATURESOFYOURVEHICLE Reprogramming A Single HomeLink Button2. Place the hand-held transmitter 1 to 3 inches (3 to 8 (Rolling Code) cm) away from the HomeLink button you would like Toreprogramachannelthathasbeenpreviouslytrained,to program while keeping the HomeLink indicator follow these steps: light in view. 1. Cycle the ignition to the ON/RUN position.3. Push and hold the HomeLink button you want to program while you push and hold the hand-held 2. Push and hold the desired HomeLink button until thetransmitter button. indicator light begins to flash after 20 seconds. Do not4. Continue to hold both buttons and observe the indi- release the button. cator light. HomeLink indicator will flash slowly and 3. Withoutreleasingthebuttonproceedwith“Program-then rapidly after HomeLink has received the fre- mingARollingCode”step2andfollowallremainingquency signal from the hand-held transmitter. Release steps. both buttons after the indicator light changes from Programming A Non-Rolling Code slow to rapid. For programming Garage Door Openers manufactured 5. Push and hold the programmed HomeLink button before 1995. and observe the indicator light. 1. Cycle the ignition to the ON/RUN position.•If the indicator light stays on constantly, program- mingiscompleteandthegaragedoor/deviceshould activate when the HomeLink button is pressed.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders