owners manual Hyundai ix20

all ratings: 0 average rating: 5

What to do in an emergency Jump starting procedure 1. Make sure the booster battery is 12- CAUTION - Battery cables volt and that its negative terminal is CAUTION -AGM battery grounded. Do not connect the jumper cable from the negative terminal of the (if equipped)2. If the booster battery is in another • Absorbent Glass Matt (AGM) bat-vehicle, do not allow the vehicles comebooster battery to the negative ter- in contact. minal of the discharged battery. teries are maintenance-free and This can cause the discharged bat- 3.Turn off all unnecessary electrical should only be serviced by a tery to overheat and crack, releas- HYUNDAI authorised repairer.Forloads. ing battery acid. charging your AGM battery, use4.Connect the jumper cables in the exact sequence shown in the illustration. only fully automatic battery chargers that are specially devel- First connect one end of a jumper 6. Start the engine of the vehicle with the oped for AGM batteries. cable to the positive terminal of the booster battery and let it run at 2,000 • When replacing the AGM battery, discharged battery (1), then connect rpm, then start the engine of the vehi- the other end to the positive terminal use only the HYUNDAI genuine cle with the discharged battery. battery for the ISG system.on the booster battery (2).If the cause of your battery discharging is • Do not open or remove the cap on5. Proceed to connect one end of the other jumper cable to the negative ter- not apparent, you should have your vehi- top of the battery.This may cause cle checked by a HYUNDAI authorised minal of the booster battery (3), then leaks of internal electrolyte that repairer. could result in severe injury.the other end to a solid, stationary, • If the AGM battery is reconnectedmetallic point (for example, the engine or replaced, ISG function will notlifting bracket) away from the battery operate immediately. (4). Do not connect it to or near any part that moves when the engine is If you want to use the ISG func- cranked. tion, the battery sensor needs to be calibrated for approximately 4Do not allow the jumper cables to con- hours with the ignition off.tact anything except the correct bat- tery terminals or the correct ground. Do not lean over the battery when making connections. 6 6

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders