or
owners manual Mini Cooper
owners manual Mini Cooper - year of production: 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000 - Mini Cooper workshop manual EN
Document:
pdf (4.74 MB) 372 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Mini Cooper, year of production 1961 - 2000:
RESTRAINTSYSTEMS
SRSANDDIAGNOSTICCONTROLUNIT
Service repair no - 76.73.72
Remove
CAUTION:Seesafetyprecautionsbefore
commencementofrepair.
1. Removekeyfromstarterswitch, disconnect
both battery leads, earth lead first, and wait 10
minutes for the SRS back-up power circuit to
discharge before starting work.
2. Slide drivers seat forward and fold down
squab.
9. RemoveTorxscrewsecuringseatbeltstalk3. Release carpet from under rear seat for access
andremovestalk. to SRS control unit.
Refit
1. Position seat belt stalk, spacer and washers, fit
Torx bolt and tighten to 32 Nm.
2. Position seat belt and pre-tensioner assembly
to body, fit and tighten bolt to 30 Nm.
3. Extend seat belt and align to upper mounting.
Fit upper mounting bolt, spacer and washers
andtighten to 32 Nm.
4. Fit cover to upper seat belt securing bolt.
5. Extend seat belt and align to lower mounting.
Fit lower mounting bolt, spacer and washers
andtighten to 30 Nm.
6. Fit nut and screw securing pre-tensioner to
body. Tighten nut to 6 Nm and screw to 1.5
Nm.
7. Connect multiplug to pre-tensioner harness
andsecuretobracketonbody. 4. Disconnect multiplug from control unit.
8. Fit rear quarter companion box. See BODY,5. Removeanddiscard3Torxscrewssecuring
Interior trim components. control unit to floor.
9. Connect both battery leads, earth lead last.6. Removecontrol unit.
10. Carry out system check by turning ignition on
andcheckthattheSRSwarninglight Refit
illuminates then extinguishes after 3 seconds.
CAUTION:Ensureunitandbracketfaces
are clean and free from burrs. An
incorrectly mounted unit could cause the
systemtomalfunction.
1. Position control unit, fit NEW Torx screws and
tighten to 9 Nm.
2. Connect harness multiplug to control unit.
3. Position floor carpet.
4. Reposition drivers seat.
5. Connect battery leads, earth lead last.
6. Carry out system check by turning the ignition
onandcheckingthattheSRSwarninglight
illuminates the extinguishes after 3 seconds.
REVISED:12/96 REPAIRS 3
Download PDF
Click here to download a pdf file with an instruction manual for Mini Cooper
year of production from: 1961
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Mini Cooper workshop manual
pages 274 - 280
Mini Cooper workshop manual
page 277 / 372
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF