owners manual Seat Alhambra

all ratings: 0 average rating: 5

Fuses and bulbs Several warning and control lamps light ups WARNING sharp elements. Always protect your hands for a few seconds when the ignition is switch- when changing bulbs. Failure to replace bulbs correctly may cause ation ed on, signalling that the function is being ific serious accidents. verified. They will switch off after a few sec- CAUTION pec ● Before carrying out any work in the engine onds. s al compartment please read and observe the ● After changing a bulb, if the rubber covers warnings ››› page 214. In any vehicle, the en- are not replaced correctly on the headlamp hnic Checking the bulbs of a trailer gine compartment is a hazardous area and ec framework, the electrical installation may be T could cause severe injury. For vehicles with the factory fitted towing damaged, especially if water is allowed to en- bracket, certain trailer lights are also control- ● Discharge lamps work with high-voltageter. led if the power socket is correctly connected. and can cause serious or fatal injury if han- ● Remove the ignition key before working on dled incorrectly. the electric system. Otherwise, a short circuit e A fault on a trailer turn signal is indicated on ic ● H7 and discharge lamps are highly pressur-could occur. the instrument panel by the turn signal blink- Adv ised and could explode when being changed. ● Switch off the lights and the parking lighting twice as fast ( or ) ››› page 74. ● Only replace the bulbs concerned whenbefore changing a bulb. ●General fault of all turn signals on one side. they have cooled. ● Take good care to avoid damaging any com- ●Fault in one tail light (on some models, al- ● Never replace bulbs alone if you are not fa-ponents. so the registration light). miliar with the operations necessary. If you are not sure about procedures then visit a ●Fault in two brake lights. specialised workshop to carry out the neces- Control lamp ation sary work. WARNING ● Never touch the bulb glass directly. Finger- Oper It Observe the safety warnings ››› in Control prints will be evaporated by the heat of the and warning lamps on page 47. lightsPossible causeSolution operating bulb thus “fogging” up the reflec- up tor. Note ● The headlamp frameworks in the engine A vehicle exterior Replace the faulty compartment and the tail lamps containlighting bulb is not  A fault in the LED on the tail lights will not be bulb. working. indicated. However, if the fault affects all the ety LEDs then this will be indicated by the control lamp . Saf 267

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders