or
owners manual Nissan Cube
owners manual Nissan Cube - year of production: 2008 - Nissan Cube owners manual EN
Document:
pdf (3 MB) 329 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Nissan Cube, year of production 2008:
Black plate (272,1)
. Waste oil must be disposed of 9. Clean and re-install the drain plug with a
properly. newwasher. Securely tighten the drain plug
. Check your local regulations. with a wrench.
Drain plug tightening torque:
(Perform steps 4 to 8 only when the engine22 to 29 ft-lb
oil filter change is needed.) (29 to 39 N·m)
4. Remove the engine under cover under theDo not use excessive force.
oil filter location by removing the bolts and10. Refill the engine with the recommended oil
small plastic clips. through the oil filler opening, and install the
5. Loosen the oil filter with an oil filter wrench.oil filler cap securely.
Remove the oil filter by turning it by hand.See “CAPACITIES AND RECOMMENDED
6. Wipe the engine oil filter mounting surfaceFUEL/LUBRICANTS” in the “9. Technical
SDI1978 with a clean rag. and consumer information” section for drain
and refill capacity. The drain and refill
1. Oil filler cap CAUTION capacity depends on the oil temperature
2. Oil drain plug and drain time. Use these specifications for
3. Oil filter Be sure to remove any old gasket reference only. Always use the dipstick to
Engine oil and filter material remaining on the mounting determine the proper amount of oil in the
1. Place a large drain pan under the drain plug.surface of the engine. Failure to do soengine.
2. Remove the oil filler cap. could lead to engine damage. 11. Start the engine and check for leakage
around the drain plug and the oil filter.
3. Remove the drain plug with a wrench and7.Coat the gasket on the new filter with cleanCorrect as required.
completely drain the oil. engine oil.
12. Turn the engine off and wait more than 10
8. Screw in the oil filter clockwise until a slightminutes. Check the oil level with the dipstick.
CAUTION resistance is felt, then tighten additionallyAdd engine oil if necessary.
more than 2/3 turn.
Be careful not to burn yourself, as theOil filter tightening torque: After the operation
engine oil is hot. 11 to 15 ft-lb 1.Install the engine undercover into position as
(14.7 to 20.5 N·m) the following steps.
8-10 Maintenance and do-it-yourself
Model "Z12-D" EDITED: 2009/ 9/ 17
Download PDF
Click here to download a pdf file with an instruction manual for Nissan Cube
year of production from: 2008
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Nissan Cube owners manual
pages 265 - 271
Nissan Cube owners manual
page 268 / 329
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF