owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 265 Montag, 30. August 2010 4:45 16 If and when 265 Changing the dipped beam headlight bulb – Switch off the ignition and the lights. The procedure for changing the bulb is the same on both – Raise the bonnet. sides. – Move the brace ⇒fig.194 1 in the direction of the arrow and A remove the rigid cover, separating the brace side and then removing the two tabs from the other end of the cover. 2 A – Pull the connector ⇒ fig. 195 from the bulb. – Unclip the retainer spring ⇒ fig. 195 3 pressing inwards to the A right. – Remove the bulb and fit the new one in the headlight casing with the tab upwards, starting to position it from below. – Clip on the spring, raising it and pressing it slightly while turning Fig. 194 Dipped beam it anti-clockwise. To ensure correct lighting, the filament must be headlights vertical. When changing the bulb, you can check the position of the bulb through the headlight glass. – Connect the connector to the bulb. – Fit the cover, first inserting the side tabs and then closing the cover and the brace. Make sure that the gasket sits well on the casing cover during the operation. – Check whether the new bulb is working. – Have the headlight settings checked as soon as possible. Fig. 195 Dipped beam headlights Safety First Operating Instructions Practical Tips Technical Specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders