owners manual Seat Leon

all ratings: 0 average rating: 5

leon_EN.book Seite 264 Donnerstag, 15. April 2010 9:19 09 264 If and when Sun visor light – Remove the bulb, moving it in the direction of the arrow and outwards ⇒fig.179. – Installation is done in the reverse order. Jump-starting Jump leads The jump lead must have a sufficient wire cross section. Fig. 178 Removing sun If the engine fails to start because of a discharged battery, the battery can be visor light connected to the battery of another vehicle to start the engine. Jump leads Jump leads must comply with standard DIN 72553 (see manufacturer's docu- mentation). The wire cross section must be at least 25 mm2 for petrol engines 2 and at least 35 mm for diesel engines. Note • The vehicles must not touch each other, otherwise electricity could flow as soon as the positive terminals are connected. • The discharged battery must be properly connected to the vehicle elec- trical system. Fig. 179 Removing sun visor light – Carefully remove the lamp, using the flat side of the screwdriver, as shown in the figure ⇒ fig. 179.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders