owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 264 Montag, 30. August 2010 4:45 16 264 If and when Changing the main headlight bulb – Switch off the ignition and the lights. The procedure for changing the bulb is the same on both – Raise the bonnet. sides. – Pull up on the rubber cover A ⇒ fig. 192 to remove it. A – Remove the connector ⇒fig.193 1 from the bulb. A –Press the spring⇒ fig. 193 2 inwards and to the right. A – Remove the bulb. pulling it from the connection terminal and fitting fit the replacement so that it sits correctly in the cut-out on the reflector. To ensure correct lighting, the filament must be vertical. When changing the bulb, you can check the position of the bulb through the headlight glass. – Installation is in reverse order, ensuring that the rubber cover is Fig. 192 Main beam well fitted to the housing. headlights – Check whether the new bulb is working. – Have the headlight settings checked as soon as possible. Fig. 193 Main beam headlights

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders