owners manual Honda Jazz

all ratings: 8 average rating: 3

Lights 4. Unclip the end of the hold-downHOLD-DOWNReplacingaParkingLight/Front wire from its slot. Pivot the wireWIRE SideMarkerBulb out of the way, then remove the bulb. 5. Install the new bulb into the hole, makingsurethetabsareintheir slots. Pivot the hold-down wire backinplace, and clip the end into the slot. INSPECTION WINDOW 6. Make sure that the hold-down wire is installed properly and securely. Maintenance Youcancheckitsinstallation from1. Open the hood. the inspection window on the headlight assembly. 2. Remove the socket by turning it 7. Install the rubber seal over theone-quarter turn counterclockwise. backoftheheadlight assembly.3. Pull the bulb straight out of its 8. Push the electrical connector ontosocket. Push the new bulb straight the new bulb. Make sure it isinto the socket until it bottoms. connected securely. Turn on the4. Reinstall the socket into the light headlights to test the new bulb.assemblybyturningitclockwise until it locks. CONTINUED 2009 Fit 263

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders