owners manual Jeep Grand Cherokee

all ratings: 0 average rating: 5

UNDERSTANDINGTHEFEATURESOFYOURVEHICLE 263 1. Cycle the ignition to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) awayfromtheHomeLink®buttonyouwishtoprogram while keeping the HomeLink® indicator light in view. 3. Simultaneously press and hold both the HomeLink® 3 button you want to program and the hand-held trans- mitter button. 4. Continue to hold both buttons and observe the indi- catorlight. The HomeLink®indicatorwillflashslowly and then rapidly after HomeLink® has received the Training The Garage Door Openerfrequency signal from the hand-held transmitter. Re- lease both buttons after the indicator light changes 1 — Door Opener from slow to rapid. 2 — Training Button 5. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING” button. This can usually be found where the hanging antenna wire is attached to the garage door opener/device motor.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders