owners manual Hyundai Veloster

all ratings: 0 average rating: 5

What to do in an emergency Jump starting procedure 1. Make sure the booster battery is 12- CAUTION - Battery cables volt and that its negative terminal is CAUTION -AGM battery grounded. Do not connect the jumper cable from the negative terminal of the (if equipped) 2. If the booster battery is in another • Absorbent Glass Matt (AGM) bat-vehicle, do not allow the vehicles comebooster battery to the negative ter- in contact. minal of the discharged battery. teries are maintenance-free and This can cause the discharged bat- we recommend that the AGM bat- 3.Turn off all unnecessary electrical tery be serviced by an authorizedloads. tery to overheat and crack, releas- 4. Connect the jumper cables in the exacting battery acid. HYUNDAI dealer. For charging your AGM battery, use only fully sequence shown in the illustration. First connect one end of a jumper automatic battery chargers that 6. Start the engine of the vehicle with the are specially developed for AGMcable to the positive terminal of the booster battery and let it run at 2,000 batteries. discharged battery (1), then connect rpm, then start the engine of the vehi- • When replacing the AGM battery, the other end to the positive terminal on the booster battery (2).cle with the discharged battery. we recommend that you use parts If the cause of your battery discharging is 5. Proceed to connect one end of the for replacement from an author- not apparent, we recommend that the ized HYUNDAI dealer. other jumper cable to the negative ter- system be checked by an authorized • Do not open or remove the cap onminal of the booster battery (3), then HYUNDAI dealer. top of the battery.This may causethe other end to a solid, stationary, metallic point (for example, the engine leaks of internal electrolyte that could result in severe injury.lifting bracket) away from the battery • If the AGM battery is reconnected(4). Do not connect it to or near any or replaced, ISG function will notpart that moves when the engine is operate immediately. cranked. Do not allow the jumper cables to con- If you want to use the ISG func- tact anything except the correct bat- tion, the battery sensor needs to be calibrated for approximately 4tery terminals or the correct ground. hours with the ignition off.Do not lean over the battery when making connections. 6 6

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders