owners manual Seat Alhambra

all ratings: 0 average rating: 5

alhambra_aleman.book Seite 251 Montag, 23. M‰rz 2009 1:12 13 If and when 251 4. Connect the other end of the black jump lead X to a solid metal A WARNING component which is bolted on to the engine block, or onto the engine block itself of the vehicle with the flat battery. Do not • Please note the safety warnings referring to working in the engine connect it to a point near the battery ⇒. compartment ⇒page211, “Working in the engine compartment”. 5. Position the leads in such a way that they cannot come into • The battery providing assistance must have the same voltage as the flat contact with any moving parts in the engine compartment.battery (12V) and approximately the same capacity (see imprint on battery). Failure to comply could result in an explosion. Starting • Never use jump leads when one of the batteries is frozen. Danger of explosion! Even after the battery has thawed, battery acid could leak and 6. Start the engine of the vehicle with the boosting battery and let cause chemical burns. If a battery freezes, it should be replaced. it run at idling speed. • Keep sparks, flames and lighted cigarettes away from batteries, danger 7. Start the engine of the car with the flat battery and wait one or of explosion. Failure to comply could result in an explosion. two minutes until the engine is “running”. • Observe the instructions provided by the manufacturer of the jump leads. Removing the jump leads • Do not connect the negative cable from the other vehicle directly to the 8. Before you remove the jump leads, switch off the headlights (if negative terminal of the flat battery. The gas emitted from the battery could they are switched on). be ignited by sparks. Danger of explosion. • Do not attach the negative cable from the other vehicle to parts of the 9. Turn on the heater blower and rear window heater in the vehicle fuel system or to the brake line. with the flat battery. This helps minimise voltage peaks which are • The non-insulated parts of the battery clamps must not be allowed to generated when the leads are disconnected. touch. The jump lead attached to the positive battery terminal must not touch metal parts of the vehicle, this can cause a short circuit. 10. When the engine is running, disconnect the leads in reverse • Position the leads in such a way that they cannot come into contact order to the details given above. with any moving parts in the engine compartment. • Do not bend over the batteries. This could result in chemical burns. Connect the battery clamps so they have good metal-to-metal contact with the battery terminals. Note If the engine fails to start, switch off the starter after about 10 seconds and The vehicles must not touch each other, otherwise electricity could flow as try again after about half a minute. soon as the positive terminals are connected. Safety First Operating instructions Tips and Maintenance Technical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders