Subaru Tribeca owners manual page 253

text version of content this owner's manual page from owners manual to the vehicle Subaru Tribeca, year of production 2005 - 2014:

7-10 Starting and operating transmitter within a few seconds immedi-! Todisengage the service modebeadjustedusingthefollowing procedure. ately following remote engine start shut-Turn the ignition switch to the“ON”1. Open the driver’s door (the driver’s down. position, depress and hold the brake door must remain opened throughout the pedal, then press and release the “ ”entire process). &Pre-heating or pre-coolingbutton on the remote engine start trans-2. Insert the key into the vehicle’s ignition the interior of the vehiclemitter three times. The system will pauseswitch and turn to the “ON” position. Before exiting the vehicle, set the tem-for 1 second and flash the parking lights3. Locate the small black programming perature controls to the desired settingone time indicating that the system hasbutton behind the fuse box cover, on the and operation. After the system starts theexited service mode.driver’s side left under the dashboard vehicle, the heater or air-conditioning willNOTEpanel. activate and heat or cool the interior toWhentakingyourvehicleinforservice,4. Pressandholdtheblackprogramming your setting. it is recommended that you inform thebutton for 10 to 15 seconds. The horn will service personnel that your vehicle ishonk and the parking lights will flash three &Service mode equipped with a remote engine starttimes to indicate that the system has In service mode, the remote start functionsystem.entered programming mode. At this point is temporarily disabled to prevent the you can perform either action (step 5 or system from unexpectedly starting the&Remoteengine start trans-step 6). engine while being serviced.mitter programming and pro-5. To program a remote transmitter: press and release the “” button on each ! Toengage the service modegrammable feature optiontransmitter. The horn will honk and the Turn the ignition switch to the “ON”New transmitters can be programmed toparking lights will flash one time to indicate position, depress and hold the brake pedalthe remote engine start system in thea successful transmitter learn each time then, press and release the “” button onevent that remote engine start transmittersthe “ ” button is pressed. You can the remote engine start transmitter threeare lost, stolen or damaged. The remoteprogram up to eight transmitters. times. The system will pause for 1 secondengine start system also has one pro-6. To toggle the Horn Confirmation chirps and then flash the parking lights and honkgrammable feature that can be adjustedON/OFF: press and release the brake to the horn three times indicating that thefor user preference.toggle the feature. The horn will chirp and system is in service mode. When attempt-The remote engine start system can bethe parking lights will flash one time to ing to activate the remote start systemprogrammed to either make an audibleindicate Confirmation Horn Chirps are while in service mode, the parking lightshorn chirp upon remote start activation or“OFF”. The horn will honk and the parking will flash and the horn will honk two timesnot. Remote engine start transmitter pro-lights will flash 2 times to indicate Con- and will not start. gramming and feature programming canfirmation Horn Chirps are “ON”. Depres-

owners manual Subaru Tribeca

owners manual Subaru Tribeca - year of production: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014 - Subaru Tribeca owners manual EN