owners manual Seat Ibiza

all ratings: 0 average rating: 5

If and when247 – Connect one end of the red jump lead to the positive + termi-Starting nal of the vehicle with the flat battery A ⇒ Fig. 172. 5. Start the engine of the vehicle with the boosting battery and let it run at idling speed. – Connect the other end of the red jump lead to the positive ter- minal + in the vehicle providing assistance B . 6. Start the engine of the vehicle with the flat battery and wait two or three minutes until the engine is “running”. – Connect one end of the black jump lead to the negative terminal – of the vehicle providing assistance B ⇒ Fig. 172. Removing the jump leads – Connect the other end of the black jump lead X to a solid met- 7. Before you remove the jump leads, switch off the dipped beam al component bolted to the engine block or to the engine block headlights (if they are switched on). itself of the vehicle with the flat battery. However, connect it to 8. Turn on the heater blower and heated rear window in the vehi- a point as far as possible from the battery A . cle with the flat battery. This helps minimise voltage peaks 3. For vehicles with Start-Stop system: which are generated when the leads are disconnected. – Connect one end of the red jump lead to the positive + termi- 9. When the engine is running, disconnect the leads in reverse or- nal of the vehicle with the flat battery A ⇒ Fig. 173. der to the details given above. – Connect the other end of the red jump lead to the positive ter- Connect the battery clamps so they have good metal-to-metal contact with minal + in the vehicle providing assistance B . the battery terminals. – Connect one end of the black jump lead X to a suitable groundIf the engine fails to start, switch off the starter after about 10 seconds and try again after about half a minute. terminal, a solid piece of metal in the engine block, or to the en- gine block ⇒ Fig. 173. WARNING – Connect the other end of the black jump lead X to a solid met- al component bolted to the engine block or to the engine block● Please note the safety warnings referring to working in the engine compartment ⇒ page 199, Working in the engine compartment. itself of the vehicle with the flat battery. However, connect it to a point as far as possible from the battery A .● The battery providing assistance must have the same voltage as the flat battery (12V) and approximately the same capacity (see imprint on 4. Position the leads in such a way that they cannot come into battery). Failure to comply could result in an explosion. contact with any moving parts in the engine compartment. Safety First Operating instructions Practical Tips Technical Specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders